QQ客服 官方微博 反馈留言

浏览/检索结果: 共30条，第1-10条 帮助 限定条件 发表日期：2018    学科主题：Metallurgy & Metallurgical Engineering     已选(0)清除 条数/页：5101520253035404550556065707580859095100   排序方式：请选择作者升序作者降序题名升序题名降序发表日期升序发表日期降序提交时间升序提交时间降序 Microstructural Degradation and the Effects on Creep Properties of a Hot Corrosion-Resistant Single-Crystal Ni-Based Superalloy During Long-Term Thermal Exposure 期刊论文 METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2018, 卷号: 49A, 期号: 11, 页码: 5309-5322 作者:  Jiang, XW;  Wang, D;  Wang, D;  Liu, XG;  Zheng, W 收藏  |  浏览/下载：23/0  |  提交时间：2018/12/25 Anomalous effects of strain rate on the room-temperature ductility of a cast Mg-Gd-Y-Zr alloy 期刊论文 ACTA MATERIALIA, 2018, 卷号: 159, 页码: 31-45 作者:  Li, JL;  Wu, D;  Chen, RS;  Han, EH 收藏  |  浏览/下载：21/0  |  提交时间：2018/12/25 Mg-Gd-Y alloy  Strain rate  Room-temperature ductility  Slip traces analysis   Constitutive equation and model validation for a 31 vol.% B4Cp/6061Al composite during hot compression 期刊论文 JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY, 2018, 卷号: 34, 期号: 10, 页码: 1730-1738 作者:  Zhou, L;  Cui, C;  Wang, QZ;  Li, C;  Xiao, BL 收藏  |  浏览/下载：186/0  |  提交时间：2018/12/25 Composites  B4C/Al  Constitutive equation  Hot compression  Finite element simulation   The influence of temperature on twinning behavior of a Mg-Gd-Y alloy during hot compression 期刊论文 MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2018, 卷号: 735, 页码: 173-181 作者:  Lu, SH;  Wu, D;  Chen, RS;  Han, EH 收藏  |  浏览/下载：172/0  |  提交时间：2018/12/25 Mg-Gd-Y alloy  Hot compression  Twin variant selection  Schmid factor   Investigation on low cycle fatigue behaviors of the [001] and [011] oriental single crystal superalloy at 760 degrees C 期刊论文 MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2018, 卷号: 734, 页码: 1-6 作者:  Liu, L;  Meng, J;  Liu, JL;  Zhang, HF;  Sun, XD 收藏  |  浏览/下载：18/0  |  提交时间：2018/12/25 Single crystal superalloy  Low cycle fatigue  Anisotropy  Deformation mechanism   Influence of temperature on the strain rate sensitivity and deformation mechanisms of nanotwinned Cu 期刊论文 SCRIPTA MATERIALIA, 2018, 卷号: 154, 页码: 54-59 作者:  Yang, LW;  Wang, CY;  Monclus, MA;  Lu, L;  Molina-Aldareguia, JM 收藏  |  浏览/下载：236/0  |  提交时间：2018/12/25 Nano twinned Cu  Indentation  High temperature deformation  Strain rate sensitivity   Effects of normal load on fretting corrosion fatigue of Alloy 690 in 285 degrees C pure water 期刊论文 CORROSION SCIENCE, 2018, 卷号: 141, 页码: 158-167 作者:  Liao, JP;  Tan, JB;  Wu, XQ;  Tang, LC;  Qian, H 收藏  |  浏览/下载：33/0  |  提交时间：2018/12/25 Alloy  SEM  Fretting corrosion  Corrosion fatigue  High-temperature corrosion   Dependence of stacking faults in gamma matrix on low-cycle fatigue behavior of a Ni-based single-crystal superalloy at elevated temperature 期刊论文 SCRIPTA MATERIALIA, 2018, 卷号: 152, 页码: 94-97 作者:  Wang, XG;  Liu, JL;  Liu, JD;  Zhou, YZ;  Li, JG 收藏  |  浏览/下载：20/0  |  提交时间：2018/12/25 Single-crystal superalloy  LCF behavior  Deformation mechanism  Stacking faults   Effect of solute atom concentration and precipitates on serrated flow in Mg-3Nd-Zn alloy 期刊论文 JOURNAL OF MATERIALS SCIENCE & TECHNOLOGY, 2018, 卷号: 34, 期号: 7, 页码: 1236-1242 作者:  Wang, WH;  Wu, D;  Chen, RS;  Zhang, XN 收藏  |  浏览/下载：39/0  |  提交时间：2018/12/25 Magnesium alloy  Serrated flow  Precipitate  Heat treatment  Deformation behavior   Strain-induced microstructure refinement in pure Al below 100 nm in size 期刊论文 ACTA MATERIALIA, 2018, 卷号: 152, 页码: 138-147 作者:  Xu, W;  Liu, XC;  Lu, K 收藏  |  浏览/下载：182/0  |  提交时间：2018/12/25 Nanolaminated structure  Pure Al  Low angle grain boundary  Structural refinement  Deformation parameters